Study of Mechanical Properties of Different Hydrate Reservoirs
DOI:
https://doi.org/10.54691/tq4wf967Keywords:
Hydrate-bearing Sediments; Triaxial Test; Stress-strain Curve.Abstract
Based on the triaxial shear tests of mud sediments in the South China Sea, mud chalk-type sediments in the South China Sea, and sandy sediments in the Nankai Trough, Japan, at different hydrate saturation and enclosing pressures, the stress-strain relationships of hydrate-bearing clays, mud chalk-type soils, and sandy soils were analyzed. The test results show that:(1)The stress-strain curves of the South China Sea clay sediments show three stages of elasticity, plastic deformation and strain hardening, which are significantly different from those of the hydrate-free clays; the stress-strain relationships of the hydrate-containing clays before and after hydrate decomposition are significantly different, and the undrained strength of the clays decreases by up to 50% after hydrate decomposition compared with that before hydrate decomposition; the above results indicate that the presence of hydrate enhances the linkage or cementation between the clay particles. The above results indicate that the presence of hydrate enhances the linkage or cementation between the clay particles.(2)For the mechanical properties of the hydrate specimens of the muddy chalky sand type in the South China Sea, the hydrate endowment, effective stresses and pore pressures all have some influence on the strength and deformation properties. The inclusion of hydrate in the pore space enhances the shear expansion characteristics of the sediments. For the effect of effective stress on the mechanical properties of hydrate sediments, the increase of effective peritectic pressure reduces the strain softening properties of hydrate sediments. The destructive strength of the sediments increases with the increase of effective confining pressure.(3)For the hydrate specimens in the Nankai Trough of Japan under the same effective circumferential pressure conditions, with the increase of hydrate saturation, the stress-strain law of the sediments showed a tendency to transform from strain hardening to strain softening, and the morphology of sandy sediment axial strain-lateral strain curves was controlled by the factors of hydrate saturation, and the absolute value of the slope of the curves expressed the rule of change of the tangent Poisson's ratio.
Downloads
References
[1] Ye Yuguang,Liu Changliang.Natural Gas Hydrates Experimental Techniques and Their Applications[M]. Germany:Springer,2013:3-10.
[2] Winters W J, Dallimore S R,Collett T S, et al. Relation between gas hydrate and physical properties at the Mallik 2L-38 research well in the Mackenzie Delta[J]. Annals New York Academy of Sciences,2000,912:94-100.
[3] Winters W J, Pecher I A, Waite W F,et al. Physical properties and rock physica models of sediment containing natural and laboratory-formed methane gas hydrate[J].American Mineralogist,2004,89: 1221-1227.
[4] Winters W J. Waite W F, Mason D H,et al, Methane gas hydrate effecton sediment acoustic and strength properties[J]. Journal of Petroleum Science and Engineering,2007,56:127-135.
[5] Waite W F, Winters W J, Mason D H. Methane hydrate formation in partially water-saturated Ottawa sand[J].American Mineralogist,2004, 89(8):1202-1207.
[6] Hyodo M, Yoneda J.Yoshimoto N,et al. Mechanical and dissociation properties of methane hydrate-bearing sand in deep seabed[J].Soils and Foundations,2013,53(2):299-314.
[7] Hyodo M, Li Y H, Yoneda J, et al. Mechanical properties of sandy sediment containing methane hydrate[J].Journal of Geophysical Research: Solid Earth, 2013, 118(10):5185-5194.
[8] Clayton C R I. Priest J A, Best A I. The effects of disseminated methane hydrate on the dynamic stiffness and damping of a sand[J].Geotech-nique,2005,55(6):423-434.
[9] Masui A, Haneda H, Ogata Y, et al. Mechanical properties of sandy sediment containing marine gas hydrates in deep sea offshore Japan[C]. Proceedings of 17th International Offshore and Polar Engineering Conference, Ocean Mining Symposium, Lisben, Portugal, 2007:53-56.
[10] Masui A, Haneda H, Ogata Y, et al. Effect of methane hydrate forma-tion on shear strength of synthetic methane hydrate sediment[C]. Proceedings of 15th International Offshore and Polar Engineering Conference, Seoul,Korea,2005:364-369.
[11] Miyazaki K, Masui A,Yamaguchi T, et al. Strain-rate dependency of peak and residual strength of sediment containing synthetic methane hydrate in triaxial compression test[C]. Proceedings of 19th International Offshore and Polar Engineering Conference, Osaka, Japan, 2009:364-369.
[12] Miyazaki K, Masui A,Sakamoto Y.Effect of confining pressure on triaxial compressive properties of artificial methane hydrate bearing sediments[C]. Offshore Technology Conference, 2010, Houston, USA, OTC2010,2010:1823-1831.
[13] Priest J A,Rees E VL. Clayton C R I. Influence of gas hydrate morphology on the seismic velocities of sands[J].Journal of Geophysical Research, 2009,114(B11):B11205.
[14] Kneafsey TJ,Morids G J. X-Ray computed tomography examination andcomparison of gas hydrate dissociation in NGHP-01 expedition (India) and Mount Elbert (Alaska) sediment cores: Experimental observations and numerical modeling[J]. Marine and Petroleum Geology, 2014,58(A): 526-536.
[15] X. H. Zhang, S. Y. Wang, Q. P. Li, et al. Experimental study on mechanical properties of natural gas hydrate-bearing sediments[J]. Geotechnics,2010,31(10):3069-3074.
[16] R. T. Yan, C. F. Wei,H. Z. Wei,et al. Effect of hydrate formation on the strength of hydrate-bearing sands[J]. Journal of Geotechnical Engineering,2012,34(7):1234-1240.
[17] Li Y H,Song Y C, Liu W G, et al. Analysis of mechanical properties and strength criteria of methane hydrate-bearing sediments[J]. International Journal of Offshore Polar Engineering, 2012,22:290-296.
[18] LI Shi, NING Fulong, YU Yibing. Mechanical properties of hydrate-bearing sediments: methods, characterization and quantitative relationships[J]. Geoscience and Technology Information,2014, 33(1):9-18.
[19] C.M. Sun, J. Zhang, C.L. Liu, et al. Determination of methane hydrate saturation in sediments and its mechanical characterization[J], Experimental Mechanics, 2013, 28(6):747-754.
[20] Zhang Lei, Liu Changling, Li Shuxia,et al. Mechanical properties andinfluencing factors of hydrate-bearing sediments[J]. Frontiers of Marine Geology,2011,6:24-28.
[21] Wang Shuyun, Luo Dashuang, Zhang Xuhui, et al. Experimental study on mechanical properties of hydrate-containing clay[J]. Experimental Mechanics,2018,33(02):245-252.
[22] Dong L, Li Y, Liao H, et al. Strength estimation for hydrate-bearing sediments based on triaxial shearing tests [J]. Journal of Petroleum Science and Engineering, 2020, 184:106478.
[23] Luo T, Li Y, Sun X, et al. Effect of sediment particle size on the me-chanical properties of CH4hydrate-bearing sediments [J]. Journal of Petroleum Science and Engineering, 2018,171:302-314.
[24] Wang Lei.Mechanical characterization and structural modeling of muddychalk hydrate reservoir in South China Sea [D]. Dalian University ofTechnology,2021.004636.
[25] Malandraki V, Toll D G. Drained probing triaxial tests on a weakly bonded artificial soil [J].Geotechnique, 2000, 50(2): 141-151.
Downloads
- Views: 1 | Downloads: 1 PDF
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.