Discussion on Material Testing of Municipal Traffic Engineering
DOI:
https://doi.org/10.54691/fse.v3i4.4769Keywords:
Material Testing; Management by Division of Responsibility; Classification and Classification; Divided Policy Implementation.Abstract
At present, the rapid development of municipal traffic engineering is in line with the high quality development trend and the demand for accurate management. The municipal traffic builders strictly control the quality from the aspects of planning and design, construction management, material testing, measurement and acceptance, among which material testing is an important part. The quality of engineering construction materials directly determines the final quality of engineering construction, so the layout and planning of material control must be done well in the actual implementation process. A preliminary investigation was conducted from the aspects of material classification and detection, material parameter selection, material grading and control, etc., so as to realize the centralized management of the three responsible parties of design, construction and suppliers, further standardize the program and standardization of municipal traffic construction projects, and achieve the goal of excellent construction project quality.
Downloads
References
Linsmeier, C., Unterberg, B., Coenen, J. W., Doerner, R. P., Greuner, H., Kreter, A., ... & Maier, H. (2017). Material testing facilities and programs for plasma-facing component testing. Nuclear Fusion, 57(9), 092012. DOI: https://doi.org/10.1088/1741-4326/aa4feb
Afshan, S., Rossi, B., & Gardner, L. (2013). Strength enhancements in cold-formed structural sections--Part I: Material testing. Journal of Constructional Steel Research, 83, 177-188. DOI: https://doi.org/10.1016/j.jcsr.2012.12.008
Pierron, F., & Grédiac, M. (2021). Towards Material Testing 2.0. A review of test design for identification of constitutive parameters from full‐field measurements. Strain, 57(1), e12370. DOI: https://doi.org/10.1111/str.12370
Krautkrämer, J., & Krautkrämer, H. (2013). Ultrasonic testing of materials. Springer Science & Business Media.
Barazzetti, L., & Scaioni, M. (2010). Development and implementation of image-based algorithms for measurement of deformations in material testing. Sensors, 10(8), 7469-7495. DOI: https://doi.org/10.3390/s100807469
von Wilmowsky, C., Moest, T., Nkenke, E., Stelzle, F., & Schlegel, K. A. (2014). Implants in bone: part II. Research on implant osseointegration: material testing, mechanical testing, imaging and histoanalytical methods. Oral and maxillofacial surgery, 18, 355-372. DOI: https://doi.org/10.1007/s10006-013-0397-2
Sarrett, D. C. (2005). Clinical challenges and the relevance of materials testing for posterior composite restorations. Dental materials, 21(1), 9-20. DOI: https://doi.org/10.1016/j.dental.2004.10.001
Szalai, S., Herold, B., Kurhan, D., Németh, A., Sysyn, M., & Fischer, S. (2023). Optimization of 3D printed rapid prototype deep drawing tools for automotive and railway sheet material testing. Infrastructures, 8(3), 43. DOI: https://doi.org/10.3390/infrastructures8030043
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
